Septic Pump Troubleshooting

When you have these problems, here are a few answers when you have water supply problems and a septic pump of your own.

Usually when you're using something mechanical you will find a challenge. It might be your work then to try and solve it, or hire someone to fix it for you. On this page we're going to consider potential problems you may have with your water supply system and try to give you a great set of solutions that will either solve it in your case or help you come up with the solution by yourself. So let's begin.

Problem 1: Excessive noise from the pump.

If this describes your condition you'll have considered trying greasing the bearings, or maybe have the motor replaced. You could also insulate the motor from concrete floors with rubber mats and inspect the values to be sure they're clean.

Problem 2: Little or no water.

The solution for this is to reprime the pump and then check the valves and suction lines for leaking. Shut off the pump until the well refills..

Problem 3: If your pump starts and stops quite frequently.

You should replace the air-volume control, then drain and refill the tank. Coat the upper tank surface with a film of soapy water if bubbles appear then have the leaks repaired or the tank replaced.

As you can see there is usually a solution to the problem you're dealing with. If yours isn't out there then try doing an online search for it and see what write. Develop this is helpful.